Crane Configuration
Crane
Liebherr LTM 1300-6.3
300-ton all-terrain hydraulic crane
Max Capacity
660k lb
Panel Weight
33,000 lb
Rigging Wt
~1,200 lb
Slings + spreader
Total Pick
34,200 lb
Panel + rigging
Boom Length
197 ft
Pick Radius
120 ft
Capacity at Radius
Load vs. Capacity
52%
34,200 lb / 65,800 lb at 120 ft radius
Critical lift threshold: 75% of rated capacity.
This lift is within normal parameters.
Per OSHA 1926 Subpart CC & ASME B30.5
This lift is within normal parameters.
Per OSHA 1926 Subpart CC & ASME B30.5
Picks
0
/ 12 panels
Waiting to start simulation...
Lift Sequence
| # | Truck | Panel | Weight | Status |
|---|
Flatbed Configuration
Trailer Length
70 ft
Panels/Truck
2
Total Trucks
6
Turn Radius
~90 ft
Entry & Route
Trucks enter from the west corner of the property via the access road adjacent to Staff Parking. Route proceeds north to the staging area in front of Building A.
Truck Queue
Safety Zones
Tail swing clearance: 18 ft from center pin
Exclusion zone: No personnel under suspended loads
Outrigger pads: 4x steel mats on compacted fill
Ground bearing: < 3,000 psf verified
OSHA Compliance
OSHA 1926 Subpart CC - Cranes & Derricks
ASME B30.5 - Mobile & Locomotive Cranes
• Qualified rigger on all picks
• Signal person required
• Pre-lift meeting completed
• Load chart posted in cab
• Daily inspection completed
• Wind speed < 25 mph
ASME B30.5 - Mobile & Locomotive Cranes
• Qualified rigger on all picks
• Signal person required
• Pre-lift meeting completed
• Load chart posted in cab
• Daily inspection completed
• Wind speed < 25 mph
Clearances
Power Lines
20+ ft
Min <350kV
Structures
10+ ft
From boom/load
Tail Swing
2+ ft
From obstruction
Personnel
Barricaded
Swing radius
Layout Configuration
Click Enter Config Mode below, then drag the bounding boxes on the blueprint to mark Building A, Building B, Staging Area, Crane, Entry, and Exit points. Drag corners to resize, drag center to move.
Building A
Bounding Box (drag on blueprint)
--
Building B
Bounding Box (drag on blueprint)
--
Staging Area
Bounding Box (drag on blueprint)
--
Crane Position
Drag crane on blueprint
--
Truck Entry Point
Drag on blueprint (where trucks arrive)
--
Truck Exit Point
Drag on blueprint (where trucks leave)
--
Coverage Check
Can crane reach all of Building A?
--
Controls
Change Assets
Speed:
1.5x
CONFIG MODE - Drag boxes to define buildings, staging, and crane position
Crane Pick Radius
Tail Swing Zone
Entry Route
Exit Route
Staging Area
Truck (loaded)
Truck (empty)